CH E3 is a single acting three part Chevron Set which consists of a cotton fabric reinforced bottom ring (BP), a rubber washer (VR) and a pom support ring (AT).
Used especially in hard working conditions such as iron and steel industry , mining equipment , marine hydraulics , scrap cutters and special cylinders where the actual conditions are difficult to predict
Suitable for open enclosures. If the enclosure height is too tight CH loses its flexibility and therefore increased wear and friction. If'm assembly tools are used the mounting area should not have any sharp edges. Before mounting the CH E3, part by part to be lubricated with oil system.
NOTES: for special applications that require high temperatures , our seal set is being manufactured with reinforced cotton fabric with FPM and special mixture of PTFE backup ring. Additional middle rings can be used depending on the application
|MATERIAL: POM / NBR FABRIC|
|MEDIA||Mineral oils(DIN 51524)||HFA and HFB||HFC|
|TEMPERATURE||-30°C +105°C||+5°C +60°C||-30°C +60°C|
|PRESSURE||≤400 Bar||≤400 Bar||≤400 Bar|
|SPEED||≤0.5 m/sn||≤0.5 m/sn||≤0.5 m/sn|
Note: The above data are maximum values and cannot be used at the same time.
|Sliding Surface Ød||≤0.4 μm||≤3.2 μm|
|Groove Base ØD||≤1.6 μm||≤6.3 μm|
|Groove Flanks B||≤3.2 μm||≤16 μm|
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
CB = Custom build (price on request)
* = Stock item
Stock = 0 (and not a Stock* or CB product) -> minimum item value € 10.00