NI is a single acting rod seal designed to have inner lip shorterthan the outer lip in order to be used for rod applications.
Construction machinery , fork-lift trucks , injection moulding machines , agricultural machinery , loading platforms and standard cylinders
Easily assembled into closed grooves according to the minimum diameter values that are given in the below table. Open grooves or special assembly tools should be used for the values that are outside this table. It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the NI must be oiled with system oil.
|MINUMUM DIAMETER VALUES FOR CLOSED TYPE OF GROOVES|
NOTES: For special applications that require high temperatures , NI can be produced in FPM material.
|PERMISSIBLE SEALING GAP Smax(mm)|
|t=(D-d)/2||50 Bar||100 Bar||150 Bar|
Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.
|MATERIAL: NBR 90 SH|
|MEDIA||Mineral oils(DIN 51524)||HFA and HFB||HFC|
|TEMPERATURE||-30°C +105°C||+5°C +60°C||-30°C +60°C|
|PRESSURE||≤150 Bar||≤150 Bar||≤150 Bar|
|SPEED||≤0.5 m/sn||≤0.5 m/sn||≤0.5 m/sn|
Note: The above data are maximum values and cannot be used at the same time.
|Sliding Surface ØD-Ød||≤0.4 μm||≤3.2 μm|
|Groove Base ØDb-Ødp||≤1.6 μm||≤10 μm|
|Groove Flanks B||≤3.2 μm||≤16 μm|
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
CB = Custom build (price on request)
* = Stock item
Stock = 0 (and not a Stock* or CB product) -> minimum item value € 10.00