VN+OR is a single acting piston - rod seal and designed to have symmetrical lips in order to be used both for rod and piston applications..O-ring acts as a spring and provides sealing contact under low pressures and shock pressures.
Fork-lift trucks , injection moulding machines , agricultural machinery , loading platforms and standard cylinders
Easy to assemble in a closed groove, depending on the minimum diameter values indicated in the table below. If the diameter values outside this table, we recommend an open groove. If'm assembly tools are used the mounting area should not have any sharp edges. Before mounting the VN+OR must be lubricated with oil system
|MINUMUM DIAMETER VALUES FOR CLOSED TYPE OF GROOVES|
|(D-d) /2 (mm)||4||5||6||7.7||10||12.5||15|
Note: the permissible sealing gap values of VN+OR piston -rod seal is given in the below table.
|PERMISSIBLE SEALING GAP Smax(mm)|
|t=(D-d)/2||150 Bar||250 Bar||400 Bar|
Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.
|MATERIAL: PU 92 SH / NBR 70 SH|
|MEDIA||Mineral oils(DIN 51524)||HFA and HFB||HFC|
|TEMPERATURE||-30°C +100°C||+5°C +50°C||-30°C +40°C|
|PRESSURE||≤400 Bar||≤400 Bar||≤400 Bar|
|SPEED||≤0.5 m/sn||≤0.5 m/sn||≤0.5 m/sn|
Note: The above data are maximum values and cannot be used at the same time.
|Sliding Surface ØD-Ød||≤0.4 μm||≤3.2 μm|
|Groove Base ØDb-Ødp||≤1.6 μm||≤10 μm|
|Groove Flanks B||≤3.2 μm||≤16 μm|
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
CB = Custom build (price on request)
* = Stock item
Stock = 0 (and not a Stock* or CB product) -> minimum item value € 10.00